Related Manuals for Clarke JSM1200
Summary of Contents for Clarke JSM1200
- Page 1 JUMPSTARTER MODEL NO: JSM1200 PART NO: 6239030 OPERATING & MAINTENANCE INSTRUCTIONS ORIGINAL INSTRUCTIONS GC08/23...
-
Page 2: Specifications
IP20 Please note that the details and specifications contained herein, are correct at the time of going to print. However, CLARKE International reserve the right to change specifications at any time without prior notice. Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 3: General Safety
DO NOT operate the device if any of the cables are damaged. Consult your CLARKE dealer for repair or replacement of the parts. DO NOT operate the device if the case is damaged. Consult your CLARKE dealer or a qualified person for inspection and repair. -
Page 4: Environmental Recycling Policy
17. Ensure the vehicle battery posts and battery clamps are perfectly clean before use. 18. Connect the red clamp to the unearthed battery terminal first, (this is usually the positive (+ve) terminal and coloured RED); then connect the black clamp to the earthed battery terminal, (this is usually the negative (- ve) terminal and coloured BLACK). - Page 5 OVERVIEW NO DESCRIPTION NO DESCRIPTION Smart Jumper Cable with Clamps 5V 1.5A Input Socket 12V USB Car Adaptor On/Off Button USB 3 in 1 Adapter Cable USB Input Socket USB Charging Cable 10 Charge Indicator/output display Jumpstart Lead Socket 11 12V DC Output socket LED Flashlight Parts &...
-
Page 6: Charging The Device
CHARGING THE DEVICE CHARGING You can charge the power pack using: • The 12V DC car adapter. • A device with a USB output socket. 1. Switch the power pack off. 2. Plug the USB charging cable into the charger input socket and the other end to the car adapter socket using the supplied adaptor, or else to a suitable appliance. -
Page 7: Operation
OPERATION WORK LIGHT 1. Push and hold the ON/OFF button for 3 seconds to turn the work light 2. Push the ON/OFF button again. • The worklight flashes on and off. 3. Push the ON/OFF button again. • The work light flashes with the morse code S-O-S pattern. - Page 8 JUMP STARTING VEHICLES WARNING: IT IS POSSIBLE THAT SOME ELECTRONIC EQUIPMENT COULD BE DAMAGED BY JUMP STARTING. ALWAYS CHECK WITH THE CAR MANUFACTURER’S HANDBOOK TO DETERMINE WHAT PRECAUTIONS IF ANY SHOULD BE TAKEN. WARNING: FAILURE TO FOLLOW THE INSTRUCTIONS BELOW AND THE SAFETY INSTRUCTIONS ON PAGES 3/4 MAY RESULT IN PERSONAL INJURY, DAMAGE TO THE VEHICLE, OR BATTERY.
-
Page 9: Starting The Engine
• Reverse polarity - Red LED solid and bleeping • Reverse charge - Red LED solid and bleeping • Overheating - Red LED solid and bleeping • Overcurrent - Green and red LED both solid CONNECTING THE JUMP START LEADS TO THE VEHICLE BATTERY ALWAYS carry out the following preliminary checks before connecting the jump-start to the car battery: •... -
Page 10: Troubleshooting
Take the unit to your Clarke internally dealer for repair. If these remedies are unsuccessful, consult your CLARKE dealer. CARE & MAINTENANCE Always ensure the cables & clamps are in good condition and the clamps are clean and corrosion free. If damaged they should be replaced. Keep the unit clean by wiping with a dry cloth. -
Page 11: Declarations Of Conformity
DECLARATIONS OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
Need help?
Do you have a question about the JSM1200 and is the answer not in the manual?
Questions and answers