Related Manuals for Clarke JSM1000
Summary of Contents for Clarke JSM1000
- Page 1 JUMPSTARTER MODEL NO: JSM1000 PART NO: 6239025 OPERATING & MAINTENANCE INSTRUCTIONS ORIGINAL INSTRUCTIONS GC08/23...
-
Page 2: Specifications
IP20 Please note that the details and specifications contained herein, are correct at the time of going to print. However, CLARKE International reserve the right to change specifications at any time without prior notice. Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 3: General Safety
DO NOT operate the device if any of the cables are damaged. Consult your CLARKE dealer for repair or replacement of the parts. DO NOT operate the device if the case is damaged. Consult your CLARKE dealer or a qualified person for inspection and repair. -
Page 4: Environmental Recycling Policy
17. Ensure the vehicle battery posts and battery clamps are perfectly clean before use. 18. Connect the red clamp to the unearthed battery terminal first, (this is usually the positive (+ve) terminal and coloured RED); then connect the black clamp to the earthed battery terminal, (this is usually the negative (-ve) terminal and coloured BLACK). - Page 5 OVERVIEW NO DESCRIPTION NO DESCRIPTION Smart Jumper Cable/Clamps LED Flashlight 12V USB Car Adaptor USB 5V Output Sockets (2.1A & 3A) USB 3 in 1 Adapter Cable Charge indicator/output display USB Charging Cable 5V 1.5A Input Socket (USB-C) Jumpstart Lead Socket 10 On/Off Button Parts &...
-
Page 6: Charging The Device
CHARGING THE DEVICE CHARGING You can charge the power pack using: • The 12V DC car adapter. • A device with a USB output socket. • You can also use a USB-C to USB-C for fast charging (sold separately) 1. Switch the power pack off. 2. -
Page 7: Operation
OPERATION WORK LIGHT 1. Push and hold the ON/OFF button for 3 seconds to turn the work light 2. Push the ON/OFF button again. • The worklight flashes on and off. 3. Push the ON/OFF button again. • The work light flashes with the morse code S-O-S pattern. - Page 8 JUMP STARTING VEHICLES WARNING: IT IS POSSIBLE THAT SOME ELECTRONIC EQUIPMENT COULD BE DAMAGED BY JUMP STARTING. ALWAYS CHECK WITH THE CAR MANUFACTURER’S HANDBOOK TO DETERMINE WHAT PRECAUTIONS IF ANY SHOULD BE TAKEN. WARNING: FAILURE TO FOLLOW THE INSTRUCTIONS BELOW AND THE SAFETY INSTRUCTIONS ON PAGES 3/4 MAY RESULT IN PERSONAL INJURY, DAMAGE TO THE VEHICLE, OR BATTERY.
-
Page 9: Starting The Engine
• Ensure the vehicle battery is rated at 12V and not damaged in any way. • Ensure the area is well ventilated. • Make sure that the battery terminals are clean and the clamps are firm and secure. • If fitted, remove any vehicle battery filler plugs and check the electrolyte level. -
Page 10: Troubleshooting
Take the unit to your Clarke internally dealer for repair. If these remedies are unsuccessful, consult your CLARKE dealer. DAILY CARE Always ensure the cables & clamps are in good condition and the clamps are clean and corrosion free. If damaged they should be replaced. Keep the unit clean by wiping with a dry cloth. -
Page 11: Declarations Of Conformity
DECLARATIONS OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
Need help?
Do you have a question about the JSM1000 and is the answer not in the manual?
Questions and answers