Subscribe to Our Youtube Channel
Related Manuals for Clarke JSM300
Summary of Contents for Clarke JSM300
- Page 1 JUMP STARTER MODEL NO: JSM300 PART NO: 6239005 OPERATION & MAINTENANCE INSTRUCTIONS ORIGINAL INSTRUCTIONS LS0620-ISS 2...
-
Page 2: Environmental Protection
INTRODUCTION Thank you for purchasing this CLARKE product. Please read this manual thoroughly and follow the instructions. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service. -
Page 3: General Safety Rules
Do not operate the device if any of the cables are damaged. Consult your Clarke dealer for repair or replacement of the parts. Do not operate the device if the case is damaged. Consult your Clarke dealer or a qualified person for inspection and repair. -
Page 4: Electrical Connections
17. Never allow the jumpstart leads, to touch each other or to touch the same metal object. 18. Ensure the vehicle battery posts and battery clamps are perfectly clean before use. 19. Connect the red clamp to the unearthed battery terminal first, (this is usually the positive (+ve) terminal and coloured RED);... - Page 5 OVERVIEW DESCRIPTION NO DESCRIPTION Worklight Jumpstart Lead Socket Charger Input Socket Power Indicator Lights 12V DC Output Socket On/Off Button USB Sockets 5V DC Supply Voltage Indicator 19V DC Output Socket Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
- Page 6 TO CHARGE THE POWER PACK You can recharge the power pack using: • The mains charger (A) or • The cigar lighter adapter (B). 1. Switch the power pack off. 2. Plug the mains charger or cigar lighter adapter into the charger input socket 3.
-
Page 7: Operation
OPERATION WORK LIGHT 1. Push and hold the ON/OFF button for 3 seconds to turn the work light 2. Push the ON/OFF button again. • The work light flashes on and off. 3. Push the ON/OFF button again. • The work light flashes with the morse code SOS pattern. -
Page 8: Dc Power Supply
DC POWER SUPPLY 1. Insert the small fly lead into the power pack. 2. Install the connector you need onto the other end of the fly lead. 3. Insert the connector into the device you want to power. 4. Push the ON/OFF button to start supplying power. -
Page 9: Jump Starting
JUMP STARTING WARNING: SOME VEHICLE ELECTRONIC EQUIPMENT MAY BE DAMAGED BY JUMP STARTING. ALWAYS CHECK WITH THE VEHICLE HANDBOOK. NOTE: This device will not jumpstart a vehicle if the battery is very low or completely flat. CONNECTING THE SMART CABLE TO THE POWER PACK 1. - Page 10 SMART CABLE STATUS LIGHTS STATUS Green LED Red LED Beeping Detecting Flashing Flashing Ready to start Solid Low Voltage Solid High Voltage Solid Short Circuit Flashing Reverse Polarity Flashing Reverse Charge Solid Solid Over heating Solid No operation within 30 seconds of connecting Solid Solid to the battery terminals...
-
Page 11: Declaration Of Conformity
DECLARATION OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
Need help?
Do you have a question about the JSM300 and is the answer not in the manual?
Questions and answers