Features And Use; Safety Precautions - Clarke Jumpstart 910 Operating & Maintenance Manual

Thank you for purchasing this Clarke Jumpstart. Before using please read these instructions.
This is for your own safety and that of others around you, and to help you achieve long and
trouble free service from the Jumpstart unit.
GUARANTEE
This product is guaranteed against faults in manufacture for 12 months from purchase date.
Keep your receipt as proof of purchase. This guarantee is invalid if the product has been
abused or tampered with in any way, or not used for the purpose for which it is intended. The
reason for return must be clearly stated. This guarantee does not affect your statutory rights.

FEATURES AND USE

The Jumpstart 910 is a rechargeable 12 Volt power supply, ideal for starting vehicles in the event of
a flat battery. The Jumpstart may also be used to power 12V appliances, such as Mobile Phones,
Radios, Electric Coolers etc. Additionally a battery powered air compressor is available to inflate
tyres, air beds, footballs etc, and a built in lamp may be used as a stand alone light source.

SAFETY PRECAUTIONS

✗
NEVER allow the negative and positive leads, on this unit, to touch or to touch the
same metal object.
✗
Although the Jumpstart is water resistant and may be used outdoors, DO NOT leave it
exposed to the elements. Avoid direct sunlight, direct heat, rain/moisture etc.
✗
The Jumpstart is designed for use with 12V systems ONLY.
✗
DO NOT operate the Jumpstart if the case or any of the cables are damaged. Consult
your Clarke dealer for repair or replacement of the parts.
✗
To prevent battery overheating and consequent damage, DO NOT exceed our
recommendations for jump starting.
✗
The Jumpstart is NOT designed to be used as a replacement for a vehicle battery.
✗
DO NOT attempt to BOOST CHARGE the Jumpstarts' sealed battery.
✗
DO NOT allow the battery, at any time, to become completely discharged.
✗
NEVER OPERATE THE AIR COMPRESSOR FOR MORE THAN 10 MINUTES. Wait a further 10
minutes (minimum) before restarting
✔
When connecting the Jumpstart leads to a battery, ALWAYS connect the RED, (positive,
+ve) output conductor to the UNEARTHED battery terminal FIRST, then connect the
BLACK, (negative, -ve) conductor to the chassis or suitable engine bolt, well away
from the battery and fuel line.
✔
ALWAYS ensure the vehicle battery posts and battery clamps are perfectly clean before use.
✔
ALWAYS ensure the area is well ventilated When jumpstarting.
✔
ALWAYS wear suitable protective clothing and eye protection when working with lead
acid batteries.
WARNING! It is possible that some electronic equipment could be damaged by
jump starting. ALWAYS check with the manufacturers handbook to determine
whether or not precautions should be taken.
- 3 -