Charging The Battery - Clarke Jumpstart 910 Operating & Maintenance Manual

CHARGING THE BATTERY

1. You MUST Charge your Jumpstart battery before using for the first time. (See 'A' below).
2. You should ALWAYS recharge the battery after every use.
3. You should ALWAYS recharge the battery every 3 months
4. You should NEVER leave your Jumpstart 910 battery in a state of discharge.
Follow the above rules to ensure maximum working life from your Jumpstart battery
Two means of charging the battery are provided.
1. Via a 230V supply, using the 230V
charger with cable and DC plug
provided, shown at 'A' Fig.2.
2. Via a 12V vehicle supply using the
cigar lighter adapter with cable and
plug provided, shown at 'B' Fig.2.
A 5 amp fuse is fitted within the cigar
lighter plug adapter, accessed by
unscrewing the end cap of the
adapter. Take care not to loose the
spring when unscrewing the cap.
NOTE : Using a 12V vehicle supply, the
battery will not charge to its maximum,
but only to approx. 50% of its capacity.
A. ....using the 230 Volt Charger
1. Plug the adapter into the socket at the front of
the unit, then the transformer into the mains
supply and switch ON. The red LED will illuminate
to denote charging is in progress.
2. Continue to charge until the RED charging light
goes OUT. It is important to note that this could
take several days, depending upon the state of
charge of the battery.
NOTE: Pressing the 'TEST' button, with the charger
disconnected, will cause the needle on the voltmeter
to register the state of charge of the battery.
Once the charger is disconnected, it will be noted
that the voltage will slowly settle back. This is quite
normal and should not cause alarm.
When the LED extinguishes, charging will
automatically stop, indicating that the battery is at
maximum capacity,
IMPORTANT! DO NOT allow the needle to enter the RED zone as this
could damage the battery
IMPORTANT!
- 6 -
Fig. 2
Fig. 3