Related Manuals for Clarke JS900
Summary of Contents for Clarke JS900
- Page 1 JUMPSTART MODEL NO: JS900/JS910 PART NO: 6240010 & 6240020 OPERATING & MAINTENANCE INSTRUCTIONS GC10/16...
-
Page 2: Specifications
Air Compressor Max output (JS910) 16 bar (240psi) Please note that the details and specifications contained herein, are correct at the time of going to print. However, CLARKE International reserve the right to change specifications at any time without prior notice. GUARANTEE This product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase. -
Page 3: General Safety Rules
5. Do not operate the jump-start if any of the cables are damaged. Consult your Clarke dealer for repair or replacement of the parts. 6. Do not operate the jump-start if the case is damaged. Consult your Clarke dealer or a qualified person for inspection and repair. -
Page 4: Environmental Recycling Policy
18. Never jump-start the engine whilst the jump-start is being charged. 19. Always store the jump-starter out of reach of children. 20. Always wear safety glasses when working with lead acid batteries. 21. If splashed by battery acid, immediately flush the area of the splash with clean water. -
Page 5: Electrical Connections
3. Should you wish to replace the fuse cover, ensure that the correct replacement is used (as indicated by marking or colour code). 4. Replacement fuse covers can be obtained from your local Clarke dealer or most electrical stockists. FUSE RATING The fuse in the plug must be replaced with one of the same rating and this replacement must be ASTA approved to BS1362. -
Page 6: Component Identification
COMPONENT IDENTIFICATION The JS900 & 910 is a rechargable power supply which can be used to start a car in the event of a flat battery. The unit can also be used to power electrical appliances via a cigarette lighter type socket using the adaptor supplied. The unit also incorporates a built-in lamp and may be used as a stand alone light source. -
Page 7: Initial Battery Charging
INITIAL BATTERY CHARGING 1. Charge your jump-start battery before using it for the first time. 2. Recharge the jump-start battery after every occasion of use if possible, and thereafter, at least every 30 days. 3. Always avoid leaving your jump-start in a discharged state. FOLLOW THE ABOVE POINTS TO ENSURE MAXIMUM LIFE FROM THE BATTERY. -
Page 8: Charging Using The 12V Adaptor
cause the needle on the voltmeter to indicate the state of charge of the battery. • Once the charger is disconnected, it will be noted that the voltage will slowly settle back. This is quite normal and should not cause alarm. - Page 9 • Ensure the battery terminals are clean and the clamps are firm and secure. • Remove any vehicle battery filler plugs and check the electrolyte level. If necessary, top up with distilled water. • Ensure the area is well ventilated. •...
-
Page 10: Using As A 12Volt Power Supply
USING AS A 12VOLT POWER SUPPLY The unit has a cigar lighter type socket located on the side of the casing (see page 6), that allows connection via a standard DC connector to other DC electrical equipment. WARNING: Be aware that a fully charged 12V battery can have an output of approx.13.5V. -
Page 11: Maintenance
Always turn the jump-start OFF during storage and store in an upright position, away from direct sunlight, moisture or sources of extreme heat or cold. NEVER attempt any repair unless your are a qualified technician. Your Clarke jump-start has been designed to give long and trouble free service. If, however, having followed the instructions in this booklet carefully, you encounter problems, take the unit to your local Clarke dealer.
Need help?
Do you have a question about the JS900 and is the answer not in the manual?
Questions and answers