Stocks That Should Not Be Used - Xerox Nuvera 100 roduction Systems Paper Manual

Selecting stock

Stocks that should not be used

The following stocks are not supported by the Xerox Nuvera.
CAUTION
Using materials that do not meet the specified requirements of the Xerox Nuvera Systems
may result in increased paper jams, poor image quality, excessive service calls, and printer
damage.
The stocks in the following table should not be run on a Xerox Nuvera System.
Note
Some paper properties are not included in the supplier's paper specifications. Order papers
with guaranteed performance from vendors with stringent quality assurance programs.
Vendors' specifications should prohibit the use of talc and plasticizer.
Stock Type
Highly conductive papers, such as foil-
backed papers
Films with melting points at or below
° °
437 F (225 C)
Papers with high moisture content
Papers containing talc or plasticizer
Preprinted sheets printed with non-laser
compatible inks or inks that are not
sufficiently cured (refer to section in
chapter 3)
Preprinted sheets that were dried with
offset drying powder
Windowed Stock
Window Clings
ID cards
1-4
Possible Printer
Damage
Possible electrical damage
to printer
Melting in the fuser
Xerox Nuvera
Poor Performance
Image quality defects
Poor image quality and
unacceptable jam rate
Poor image quality, poor
paper handling and printer
contamination
Poor image quality, poor
paper handling and printer
contamination
Poor image quality, poor
paper handling and printer
contamination
Unacceptable jam rate
Unacceptable jam rate
Unacceptable jam rate
Paper Guide