Table of Contents
Advertisement
Xerox Nuvera
Tabs
Note
A special tabs guide must be installed on the trail edge paper guide before tabs can be
loaded and run from a paper tray. Tabs can be run from any tray when the appropriate guide
is installed. Refer to Appendix B for more information.
Description
Tabs are cover weight sheets that are slightly longer in one dimension than normal
size sheets and are used to mark off sections. Pre-cut tabs are stamped to remove all
but a small tab, typically come in sets of three or five, and are arranged in a particular
order. Full cut tabs have a larger, uniform section that protrudes beyond the standard
sized sheets and are not arranged in a particular order.
Selection tips
•
Refer to the section if tabs have pre-punched holes to ensure hole pattern is
acceptable.
•
Tabs with a sequence of 1 to 31 can be run.
Storage tips
Follow general guidelines in Chapter 2.
Usage tips
•
Pre-cut tabs must be loaded in paper trays for long edge feed.
•
Only use single straight (forward) collated tabs with the DS5000 stacker. The job
should be programmed with 1-N order and face down delivery.
•
A5/5.5" tabs can not be run to the stacker due to the stacker size limitation.
These tabs can only be programmed to the top tray.
•
When loading pre-cut tabs, the tab side of the sheets must be on the trail edge.
Refer to the label in the paper tray.
•
When running tab stock with coated or laminated tabs, limit the stacks in feeder
trays to 200 sheets to prevent jamming. If jamming occurs, reduce the number
of sheets to 50.
Paper Guide
Tips by stock type
3-11
Hide quick links:
Advertisement
Table of Contents
