Table of Contents
Advertisement
Xerox Nuvera
Load tab stock in a paper tray
Note
A special tabs guide must be installed on the trail edge paper guide before tabs can be
loaded and run from a feeder tray. Two tab guides are included with each feeder module.
See Appendix B: Printing with tabs for more information. Contact the Xerox Customer
Support center if you are not sure if the appropriate hardware is installed.
Note
Load straight (forward) collated tab stock when printing 1-sided tabs with a DS5000 or
BFM type finisher. Load reverse collated tabs when printing with a Multi-Function Finisher.
To prevent stock handling problems, do not use tabs over 1/2 inch (13 millimeters) for
duplex printing.
To add tab stock to feeder tray:
1. Wait for the LED on the tray to turn off before opening the tray.
2. When the LED is off, pull the feeder tray out from the feeder until it stops.
3. Move the side and trail edge guides away from the stack.
4. Load the required stock in the tray.
Note
When loading pre-cut tabs, the tab side of the sheets must be on the trail edge. Refer to the
label in the feeder tray. When running coated tab stock, limit the stacks in feeder trays to
200 sheets to prevent jamming.
5. Position the stock against the leading (left) edge of the tray.
6. Move the rear and side guides until they touch the stack.
7. Close the tray slowly, but firmly, until it latches.
Prevent a tray from feeding
1. Select the tray to be programmed. The table row is highlighted.
2. Right-click on the tray to be disabled.
CAUTION
Selecting Disable Tray to prevent a tray from feeding will delete the stock attributes for the
tray. Make a note of the precise stock name to facilitate reprogramming the tray for the
currently programed stock.
3. Select [Tray: Disable Tray].
View a list of paper trays and their settings
To display a list of paper trays attached to the IOT, select Paper Trays from the Printer menu.
Paper Guide
Managing the Feeder
C-3
Hide quick links:
Advertisement
Table of Contents
