Restart Screen; Language Screen - ZyXEL Communications NBG5615 User Manual

Table 82 Maintenance > Backup/Restore (continued)
LABEL
Upload
Reset
Note: If you uploaded the default configuration file you may need to change the IP
address of your computer to be in the same subnet as that of the default NBG5615
IP address (192.168.1.1). See
your computer's IP address.

24.8 Restart Screen

System restart allows you to reboot the NBG5615 without turning the power off.
Click Maintenance > Restart to open the following screen.
Figure 126 Maintenance > Restart
Click Restart to have the NBG5615 reboot. This does not affect the NBG5615's configuration.

24.9 Language Screen

Use this screen to change the language for the Web Configurator.
Select the language you prefer and click Apply. The Web Configurator language changes after a
while without restarting the NBG5615.
NBG5615 User's Guide
DESCRIPTION
Click Upload to begin the upload process.
Note: Do not turn off the NBG5615 while configuration file upload is in progress.
After you see a "configuration upload successful" screen, you must then wait one minute
before logging into the NBG5615 again. The NBG5615 automatically restarts in this time
causing a temporary network disconnect.
If you see an error screen, click Back to return to the Backup/Restore screen.
Pressing the Reset button in this section clears all user-entered configuration information
and returns the NBG5615 to its factory defaults.
You can also press the RESET button on the rear panel to reset the factory defaults of your
NBG5615. Refer to the chapter about introducing the Web Configurator for more
information on the RESET button.
Appendix B on page 221
Chapter 24 Maintenance
for details on how to set up
199