Mac Filter Screen - ZyXEL Communications NBG5615 User Manual

Table 43 Network > Wireless LAN 2.4G/5G > More AP: Edit (continued)
LABEL
Enable
Bandwidth
Management
for Guest
WLAN
Maximum
Bandwidth
Security Mode
Apply
Cancel

12.5 MAC Filter Screen

The MAC filter screen allows you to configure the NBG5615 to give exclusive access to devices
(Allow) or exclude devices from accessing the NBG5615 (Deny). Every Ethernet device has a
unique MAC (Media Access Control) address. The MAC address is assigned at the factory and
consists of six pairs of hexadecimal characters, for example, 00:A0:C5:00:00:02. You need to know
the MAC address of the devices to configure this screen.
To change your NBG5615's MAC filter settings, click Network > Wireless LAN 2.4G/5G > MAC
Filter. The screen appears as shown.
NBG5615 User's Guide
DESCRIPTION
Select this to turn on bandwidth management for the Guest WLAN network.
Enter a number to specify maximum bandwidth the Guest WLAN network can use.
Select Static WEP, WPA-PSK, WPA, WPA2-PSK or WPA2 to add security on this
wireless network. The wireless clients which want to associate to this network must have
same wireless security settings as this device. After you select to use a security, additional
options appears in this screen. See
different security modes. Or you can select No Security to allow any client to associate
this network without authentication.
Note: If the WPS function is enabled (default), only No Security and WPA2-PSK are
available in this field.
Click Apply to save your changes back to the NBG5615.
Click Cancel to reload the previous configuration for this screen.
Section 12.3 on page 112 for detailed information on
Chapter 12 Wireless LAN
121