The Mac Filter Screen - ZyXEL Communications WAH7608 User Manual

The following table describes the labels in this screen.
Table 28 Configuration > WiFi > WPS
LABEL
Enable
Configure
Method
Enrollee PIN

12.4 The MAC Filter Screen

This screen allows you to configure the WAH7608 to exclude specific devices from accessing the
WAH7608 (Deny listed stations). Every Ethernet device has a unique MAC (Media Access Control)
address. The MAC address is assigned at the factory and consists of six pairs of hexadecimal characters,
for example, 00:A0:C5:00:00:02. You need to know the MAC addresses of the devices to configure this
screen.
Use this screen to view your WAH7608's MAC filter settings and add new MAC filter rules. Click
Configuration > WiFi > MAC Filter. The screen appears as shown.
Figure 55 Configuration > WiFi > MAC Filter
Chapter 12 WiFi
DESCRIPTION
Select the check box to activate WPS on the WAH7608.
• Select PBC to set up a WPS wireless network using Push Button Configuration (PBC).
If you select PBC, press the physical WPS button on the WAH7608 to add another WPS-enabled
wireless device (within wireless range of the WAH7608) to your wireless network.
Note: You must press the other wireless device's WPS button within two minutes of
pressing this button.
• Select PIN to set up a WPS wireless network by entering the PIN of the client into the
WAH7608.
This field is available only when you set Configure Method to PIN.
Select this option and enter the PIN of the device that you are setting up a WPS connection with
and click Apply to authenticate and add the wireless device to your wireless network.
You can find the PIN either on the outside of the device, or by checking the device's settings.
Note: You must also activate WPS on that device within two minutes to have it
present its PIN to the WAH7608.
WAH7608 User's Guide
93