Table of Contents
Advertisement
Continental
Troubleshooting Tips
Please refer to this troubleshooting guide before
requesting service or contacting your dealer for assistance.
Problems and Possible Remedies
Fan will not start
•
Check the main circuit fuses, circuit breakers, and wall
control position. Check all wire connections. Make
sure the power is turned off during this inspection.
Fan wobbles or shakes excessively
•
Be sure the canopy pin is set properly into the slot on
the ball.
•
The crossbar mounting bracket may be attached too
loosely. Make sure the bracket is attached tightly to the
ceiling and the downrod assembly is secured firmly.
•
The downrod may be attached to the downrod base
too loosely. Make sure all the screws are securely
tightened.
Fan is noisy during operation
•
Tighten the canopy screws and mounting plate
assembly. Make sure the wire nuts inside the
canopy and switch housing are not touching
the metal parts and that they have not fallen
off the wire splices. Tighten as necessary.
•
Tighten the blade irons to the flywheel (or Direct Drive
motor) and the blades to the blade iron screws.
•
Make sure all the screws in the motor housing are snug
but not overly tight.
Fan does not run on low speed
•
If the fan is new, it may need to be "broken
in." Run at high speed for several days.
22
™
Care Recommendations
Fan Finishes
•
For cleaning, use a soft brush or lint-free
cloth to prevent scratching the finish.
•
Surface smudges or an accumulation of dirt
and dust can be removed easily using a mild
detergent and slightly dampened soft cloth. An
antistatic agent may be used (on the fan base
and blades only), but never use abrasive cleaning
agents as these will damage the finish.
Blades
•
Wood-finish blades should be cleaned with
a furniture polishing cloth. Occasionally, a
light coat of furniture polish may be applied
for added protection and beauty.
•
For painted and high-gloss blades, surface
smudges or an accumulation of dirt and dust can
be removed easily using a mild detergent and
slightly dampened soft cloth. An antistatic agent
may be used, but never use abrasive cleaning
agents as these will damage the finish.
No Need for Lubrication
•
Never lubricate this fan! The precision motor
at the heart of your Casablanca fan features
sealed bearings that are lubricated for life.
•
Do not attempt to oil the motor.
Changing Lightbulbs
•
Be sure to turn the power to OFF at the wall control
or circuit breaker before changing lightbulbs.
•
Replace bulbs with the same type as you
removed from the light fixture.
•
In compliance with US Federal Energy Regulations,
this ceiling fan contains a device that restricts the
light kit to a maximum of 190 watts. Exceeding
that limit or the marked limit on this product may
result in a fire hazard or improper operation.
Advertisement
Table of Contents
