Casablanca Continental Owner's Manual page 12

Continental
3
Route the fan wires through the
downrod and ball assembly.
4
Insert the downrod into the motor coupling
and turn clockwise. When the downrod is securely in
place, re-tighten the set screw with the Allen wrench
until it will not turn any further. Test the stability of
the downrod assembly by attempting to unscrew the
downrod from the motor coupling. If the downrod turns
in either direction, the set screw should be tightened.
Ñ
CAUTION:
The downrod has a tapered
thread designed to lock completely when
correctly installed. Failure to fully lock in
the downrod before securely tightening
the set screw may cause the fan to
separate from the downrod and fall during
normal operation.
5
Remove the three screws and top cover ring
from the top of the motor housing. Set them aside.
6
Screw in the six lightbulbs.
7
Reinstall the top cover ring using the
three screws set aside in Step 5.
12
™
STEPS 3-4
Downrod and ball
assembly
Set screw
Allen
wrench
STEPS 5-6
Screws (3)
STEP 7
Tapered
thread
Motor
wires
Motor
coupling