Advertisement
20) Barcode width size setting
Code: [1D]h• { [77]h• { n
Specifies the width of barcode.
* The default value is '3'.
21) Barcode height setting
Code:[1D]h• { [68]h• { n1• { n2
Specifies the height of barcode (mm).
* n1n2 indicates the height of barcode in mm.
* The default value of n1n2 is '20'.
22) HRI characters print/edit setting < GS H n >
Code: [1D]h + [48]h + n
* The edit by n value is specified as follows:
‚ Ž
'0' No print/edit
'1' Print/edit below barcode
* The default value of n is '0'.
23) Barcode modification total setting < GS X n1 n2 n3 n4 >
Code: [1D]h [58]h + n1 +n2 + n3 + n4
Totally sets the modification of barcode for print/edit
* n1 is the same with the parameter of "HRI character print/edit setting", n2 is the same
with parameter of "Barcode width size setting" and n3n4 the same with parameter of
"Barcode height setting".
24) Black mark position margin setting < ESC b n1 n2 n3 >
Code: [1B]h + [62]h + n1+ n2+ n3
Set the margin from paper perforation to blackmark position by unit of dot (0.125mm/dot).
* The margin quantity that can be set is n1n2n3• ~ 0.123(mm)
*Setting function is effective until it is reset or software are downloaded.
(Setting function is not cleared even when it is switched off/on or printer is initialized.)
*The default value of n1n2n3 is '255'.
25) Send printer status < ESC v>
Code : [1B]h + [76]h + n
For the detail, please refer to [Send printer status] of lime mode.
26) Firmware download < GS d Dn>
Code : [1D]h + [64]h + Dn
For the detail, please refer to [Firmware download] of line mode.
< GS w n >
< GS h n1 n2 >
Print/edit
*['2'• ... n• ... '4']
* ['01'• ... n1n2• ... '70']
* ['0'• ... n• ... '1']
*[`000`• ... n1n2n3• ... `999']
44
* ['0'• ... n1• ... '1']
* ['2'• ... n2• ... '4']
* ['01'• ... n3n4• ... '70']
Advertisement
