Advertisement
47) Partition drive select
Code
Description
* "n" indicates the following:
n(HEX)
01
02
03
* Default value is selected by the DIP switch (1 or 2 partitions).
* If assigned beyond the specified area, the data is neglected and the select will not
change.
* Automatic partition is as follows:
NP-345
48) Print density set
Code
Description
* "n" ranges from 41h(65%) to 87h(135%). However, make sure to set it for actual
use in the range 41h (65%) ≤ n ≤ 82h (130%).
* At the initial status, 100% or 125% can be selected by the DIP switch, S2-8.
* It is set by the unit of dot line.
* This command has priority over the setting by DIP switch.
49) Page mode select << ESC L >>
Code
Description
* The data in the line buffer is cleared.
* Clear the each setting and definition of the line mode.
* The default value is in the page mode.
:<< GS % n >>
: < 1D > h + < 25 > h + n
: Selects partition drive.
Divide
1 fixed partition
2 fixed partitions
automatic partition
1 partition
Less than 287 dots
:<< GS ˉ n >>
: < 1D > h + < 7E > h + n
: Sets print density in the range between 65% ~ 135% of the standard
value, S2-8 Off.
: [1B]h + [4C]h
: Switches between the line mode and page mode.
* < 01≤n≤03 >h
2 partitions
More than 288 dots
* [ 41≤n≤87 ]h
33
Advertisement
