Advertisement
37) Data input control :<< ESC = n >>
Code
Description:Selects valid device where data input is possible through host computer.
* Each bit of "n" has the following meaning.
Bit
Function
0
Printer
1
Not defined
2
Not defined
3
Not defined
4
Not defined
5
Not defined
6
Not defined
7
Not defined
* If printer is not in "no selection" status, printer will discard all received data until it
is in the selection status by this command.
* Even if printer is in no selection status, the status may become BUSY by printer
operation.
* The default value of "n" is [00]h.
38) Print position alignment
Code
Description : Aligns all data to be printed on the assigned position in a line.
* "n" values are assigned to:
n (Hex)
00
01
02
* This command is valid only when it is input at the head of a line.
* The default value of "n" is [00]h.
39) No paper sensor select
Black mark sensor command
Code
* n1 = 0, no paper sensor
* n1 = 1, black mark sensor (label paper)
* Value "n2" is available only at label selection in "n1".
Feeds paper by dots assigned after black mark position is confirmed.
Feeds 0.125mm x "n2" amount of paper
Default value of n1 is [00]h.
Auto loading function is not available at black mark selection.
: < 1B >h + < 3D >h + n
Values
0
Invalid
:<< ESC a n >>
: < 1B >h + < 61 >h + n
Position
Left
Center
Right
:<<ESC c 3 n1 n2>>
:<1B>h + <63>h + <33>h + n1 + n2 * < 00≤n1≤01 >h
(thermal paper)
* < 00≤n≤FF >h
1
Valid
* < 00≤n2≤FF >h
28
* < 00≤n≤02 >h
Advertisement
