Advertisement
15) Absolute position setting <ESC $ n1 n2 >
Code: [1B] h + [2A] h + n1 + n2
The next print/edit position is specified by the dot numbers from the line start.
* Print total dots divided by 256, quotient is n2 and remainder is n1.
* The print/edit position will be at n1 + (256 x n2) from the start position.
* The specified position, exceeding the end of line is disregarded.
16• j Bit image mode setting
Code:• k 1B• l h• { • k
The data is print/edited in the bit image by following the bit image mode specified by m.
* Divide the print/edit dot width by 256, quotient is n2 and remainder is n1.
* If the bit image data (Dn) is input beyond the dot width and line, the exceeded data is
ignored.
* The bit image data (Dn) to be printed is bit 1 and the data not printed is 0.
* The bit image mode (m) is indicated below:
m(hex)
00
01
21
23
24 dot double density
* This command is effective for < print/edit direction "0" >
* When using Windows driver, set the Dip switch S-3 ON.
< ESC * m n1 n2 Dn >
2A• l h• { m• { n1• { n2• { Dn
Mode
8 dot single density
8 dot double density
24 dot single density
* [00≤n1≤FF] h
* [00≤n2≤04] h
*• k m• • 00,01,21,23• l h
* [00• ... n1• ... FF• l h
*• k 00• ... n2• ... 04• l h
Vertical direction Horizontal direction
Dots
Density
Density Max. dots
8
67DPI
101DPI
8
67DPI
203DPI
24
203DPI
101DPI
24
203DPI
203DPI
41
592
1184
592
1184
Advertisement
