Casablanca Tercera Owner's Manual page 9

Step_3._ Slide the Canopy, Trim Ring, Hanging
Adapter Cover on to the pole, then route the
wires through the 3.5" Perma•Lock downrod and
ball assembly as shown in Figure #3. Insert the
downrod into the motor coupling and turn it
clockwise until it stops turning, ensuring that the
pole has bottomed out.
Tip: The downrod has a tapered thread that
is designed to lock completely when installed
correctly.
Step_4._ Tighten the set screw as shown in Figure
#4 to ensure safe operation of your fan. If it is tight
enough, you should not be able to turn the downrod
counterclockwise with your hands. If in doubt, tighten
the set screw with until you cannot turn it any further.
t
ercera
Canopy
Trim Ring
Hanging
Adapter Cover
FIGURE_3.
CAUTION: Failure to fully lock in the
downrod before securely tightening the
Set Screw may cause the fan to separate
from the downrod and fall during normal
operation.
FIGURE_4.
™
MOTOR WIRES
(LEAVE AT LEAST
6" LONG)
PERMA•LOCK™
DOWNROD AND
BALL ASSEMBLY
MOTOR
COUPLING
SET SCREW
Set Screw
9