How To Set Up A Wireless Network; Example Parameters; Configuring The Ap - ZyXEL Communications FSG2200HNU User Manual

Chapter 3 Tutorial

3.3 How to Set up a Wireless Network

This section gives you examples of how to set up an access point and wireless
client for wireless communication using the following parameters. The wireless
clients can access the Internet through the ZyXEL Device wirelessly.

3.3.1 Example Parameters

SSID
Security
802.11 mode
An access point (AP) or wireless router is referred to as the "AP" and a computer
with a wireless network card or USB adapter is referred to as the "wireless client"
here.
The M-302 utility screens are used here as an example. The screens may vary
slightly for different models.

3.3.2 Configuring the AP

Follow the steps below to configure the wireless settings on your AP.
Open the Network > Wireless LAN > General screen in the AP's web
1
configurator.
Tutorial: Network > Wireless LAN > General
Make sure Enable Wireless LAN is selected.
2
Enter "SSID_Example3" as the SSID and select a channel which is not used by
3
another AP.
46
SSID_Example3
WPA-PSK
(Pre-Shared Key: ThisismyWPA-PSKpre-sharedkey)
802.11b/g/n
FSG2200HNU User's Guide