Table of Contents
Advertisement
The following table describes the labels in this screen.
Table 20 Network > WAN > Multicast
LABEL
WAN Interface
WAN Status
Apply
Cancel
5.5 Technical Reference
The following section contains additional technical information about the ZyXEL
Device features described in this chapter.
Encapsulation
Be sure to use the encapsulation method required by your ISP. The ZyXEL Device
can work in bridge mode or routing mode. When the ZyXEL Device is in routing
mode, it supports the following methods.
IP over Ethernet
IP over Ethernet (IPoE) is an alternative to PPPoE. IP packets are being delivered
across an Ethernet network, without using PPP encapsulation. They are routed
between the Ethernet interface and the WAN interface and then formatted so that
they can be understood in a bridged environment. For instance, it encapsulates
routed Ethernet frames into bridged Ethernet cells.
PPP over Ethernet
Point-to-Point Protocol over Ethernet (PPPoE) provides access control and billing
functionality in a manner similar to dial-up services using PPP. PPPoE is an IETF
standard (RFC 2516) specifying how a personal computer (PC) interacts with a
broadband modem (DSL, cable, wireless, etc.) connection.
For the service provider, PPPoE offers an access and authentication method that
works with existing access control systems (for example RADIUS).
FSG2200HNU User's Guide
DESCRIPTION
Select the WAN interface you want to use for multicast traffic. Refer to
Section 5.2 on page 76
to know more about WAN interfaces and read
about
Multicast on page
according to multicast membership.
Select Disable Multicast if you do not want to use any WAN interface
for multicast traffic.
This shows whether the WAN interface is currently Up (available) or
Down (not available).
Click this to save your changes back to the ZyXEL Device.
Click this to begin configuring this screen afresh.
91. Traffic received on this interface is sorted
Chapter 5 WAN Setup
89
Advertisement
Table of Contents
