Upgrade The Products On 4400 Appliances - McAfee DTP-1650-MGRA - Network DLP Manager 1650 Appliance Installation Manual

2
Installing or upgrading the software on 4400 appliances

Upgrade the products on 4400 appliances

Run the installation script.
6
# ./install_new_full <product> .
The product image installs on the primary and secondary disks.
Restart the system.
7
# reboot
Log on to the McAfee DLP device as root, go to the installation directory, and verify the installation
8
with the command:
# cat /data/stingray/etc/version
If the Release field contains 9.2.1, installation is complete.
Upgrade the products on 4400 appliances
To upgrade a product on the 4400 appliance, you must install the new image on the disk that is not
used by the previous installation. This ensures that the original image can still be accessed after the
upgrade is complete. The system automatically boots from the latest image.
Before you begin
Download the product archive and copy it to the appliance.
If you want to do a backup before upgrading to 9.2.1 on a 4400 appliance that is running McAfee Data
Loss Prevention Manager 9.2.0 or one of the standalone McAfee DLP appliances, you must first apply
Hotfix 754037_45668_01.
The install_to_pri and install_to_sec scripts install the upgrade. After the process runs, the
existing configuration and database are copied to the new image.
Task
Log on as root to the model 4400 appliance.
1
18 McAfee Data Loss Prevention 9.2.1
Before you type in the command, run pwd to establish that you are in the correct product directory.
You must be sure that you are running the updated scripts in the upgrade archive that you just
downloaded and extracted.
iGuard was the original name of McAfee DLP Monitor, but the archives have not been renamed.
Restarting the system might take 10–15 minutes.
Stop all scans and search tasks before upgrading, and wait until they are completely stopped before
upgrading.
Without a backup, the data, settings, and configuration on your 4400 might be lost if there is a system
failure.
If you use the wrong script, you will write over your existing installation.
Installation Guide