Complete The Setup - McAfee DTP-1650-MGRA - Network DLP Manager 1650 Appliance Installation Manual

1
Setting up the hardware

Complete the setup

Integrate the appliance using a network tap
Task
Disconnect the cable between your WAN router and your LAN switch.
1
Connect Monitor Port A of the network tap to Capture Port 0 on McAfee DLP Monitor.
2
Connect Monitor Port B of the network tap to Capture Port 1 on McAfee DLP Monitor.
3
Connect Network Port A of the network tap to a router inside the firewall.
4
Connect Network Port B of the network tap to the LAN switch.
5
Complete the setup
Add the NTP server to sync McAfee DLP Manager to the network.
Task
Open a web browser and enter the assigned IP address in the address bar to restart McAfee DLP
1
Manager.
Click the System tab and select the Configure link.
2
Scroll down to the Time section and enter the NTP server.
3
pool.ntp.org
Click Time at Server to verify the current time.
4
Click Update.
5
Configuration is complete. If you want to integrate the DLP system into McAfee
4.5 or 4.6, you can do it now.
14 McAfee Data Loss Prevention 9.2.1
® ePolicy Orchestrator ®
Installation Guide