Configure Mcafee Dlp Manager - McAfee DTP-1650-MGRA - Network DLP Manager 1650 Appliance Installation Manual

1
Setting up the hardware

Configure McAfee DLP Manager

You must connect a laptop to the management port so you can convey this information to the
appliance. Assign the laptop an IP address that is different, but on the same subnet, so it can access
the management port.
Task
Connect a laptop to the management port of the appliance using the supplied Ethernet cable.
1
Change the laptop to an address in the 192.168.1.X/24 IP range — for example, 192.168.1.10.
2
Open a web browser and connect to the DLP appliance.
3
https://192.168.1.2
The DLP user interface starts.
Log on to the McAfee DLP appliance.
4
The default logon is admin/mcafee.
The End User License Agreement appears.
Select the license agreement checkbox and click I Accept.
5
The Setup Wizard starts.
On the Network Configuration page, enter all of the IP addresses, and the host and domain names
6
needed to integrate the appliance into the network.
If you are configuring a McAfee DLP Manager, skip to the next topic.
Advance through the Setup Wizard pages to the Review page.
7
The interim pages will be completed only on the McAfee DLP Manager appliance.
Click Submit, then Exit Wizard.
8
When this step is complete, the appliance will have a new IP address and will be integrated into the
network. Restarting is not necessary.
If you have configured McAfee DLP Discover or McAfee DLP Prevent appliances, setup is complete. If
you are configuring McAfee DLP Manager, proceed to the next step. If you are configuring McAfee DLP
Monitor, proceed to the following step.
Configure McAfee DLP Manager
When you configure McAfee DLP Manager, you must provide additional information after the network
configuration is completed.
Before you begin
You must have completed the network settings required on the Network Configuration page of
the Setup Wizard.
Task
On the Time Configuration page, change the time zone.
1
Select Manual to set NTP to local time.
2
On this first configuration, you will not yet be able to set the NTP server because the default IP
address (192.168.1.2) will not allow it to be located. The NTP server can be defined only when the
system is restarted and integrated into the network.
10 McAfee Data Loss Prevention 9.2.1 Installation Guide