Cisco TelePresence System Codec C40 Administrator's Manual page 64

Cisco TelePresence System Codec C40/C60 and Profiles using C40/60
Contents
Audio Output HDMI [1] Mode
Determine if the audio channel on the HDMI output connector shall be enabled.
Requires user role: ADMIN
Value space: <Off/On>
Off: Disable the audio channel on the HDMI output.
On: Enable the audio channel on the HDMI output.
Audio Output HDMI 1 Mode: On
Example:
Audio Output Line [1..2] Channel
Define whether the Audio Line output is a mono signal or part of a multichannel signal.
Requires user role: ADMIN
Value space: <Right/Left/Mono>
Right: The Audio Line output signal is the right channel of a stereo signal.
Left: The Audio Line output signal is the left channel of a stereo signal.
Mono: The Audio Line output signal is a mono signal.
Audio Output Line 1 Channel: left
Example:
Audio Output Line [1..2] Equalizer ID
Select the audio output line equalizer ID.
Requires user role: ADMIN
Value space: <1..8>
Range: Select EqualizerID 1 to 8.
Audio Output Line 1 Equalizer ID: 1
Example:
Audio Output Line [1..2] Equalizer Mode
Set the audio output line equalizer mode.
Requires user role: ADMIN
Value space: <Off/On>
Off: No equalizer.
On: Enable the equalizer for the audio output line.
Audio Output Line 1 Equalizer Mode: Off
Example:
D14636.13 Profile C60-C40 and Codec C60-C40 Administrator Guide TC7.0, DECEMBER 2013.
Introduction Web interface System settings System settings
Audio Output Line [1..2] Level
Define the output level of the Audio Output Line connector, in steps of 1 dB.
See the Audio Level tables in the Physical Interfaces Guide for the codec for a complete
overview of the menu values represented in dB.
Requires user role: ADMIN
Value space: <-24..0>
Range: Select a value from -24 to 0 dB.
Audio Output Line 1 Level: -10
Example:
Audio Output Line [1..2] Mode
Set the audio output line mode.
Requires user role: ADMIN
Value space: <Off/On>
Off: Disable the Audio Line output.
On: Enable the Audio Line output.
Audio Output Line 1 Mode: On
Example:
Audio Output Line [1] Type
Determine if the Audio Line output will be analog or digital type output. The digital output on the
Cisco TelePresence Profile systems are identified as DNAM (Digital Natural Audio Module).
Requires user role: ADMIN
Value space: <Auto/SPDIF>
Auto: If a Digital NAM is detected then SPDIF mode will be selected, otherwise analog mode
will be selected.
SPDIF: Set to SPDIF when you want the line output to be in digital mode.
Audio Output Line 1 Type: Auto
Example:
www.cisco.com — Copyright © 2010-2013 Cisco Systems, Inc. All rights reserved.
64
Administrator Guide
Setting passwords Appendices