Accessing Call Information - Cisco TelePresence System Codec C40 Administrator's Manual

Cisco TelePresence System Codec C40/C60 and Profiles using C40/60
Contents

Accessing call information

A call state indicator is avaiable in the top bar in the web
interface. It shows whether the system is in a call or not, and
how many calls it is engaged in. You may also be notified
about incoming calls.
D14636.13 Profile C60-C40 and Codec C60-C40 Administrator Guide TC7.0, DECEMBER 2013.
Introduction Web interface Web interface
Incoming call notification
As default, a notification is given when the
system receives a call.
Check this box, if you do not want to receive
such notifications.
Opening the Call Control page
Click Open Call Control
System settings
to go straight to the Call Control page.
www.cisco.com — Copyright © 2010-2013 Cisco Systems, Inc. All rights reserved.
26
Administrator Guide
Setting passwords Appendices
Call state indicator
The call state indicator is
available on all pages except
the Call Control
The badge indicates the number
of active calls. If the system is
idle, there is no badge.
Click the indicator to get more
details about connected calls.
Use these buttons to:
• Show call details
• Put the call on hold
• Disconnect the call
page.
Call control