Conference Settings; Conference [1..1] Micunmuteondisconnect Mode - Cisco TelePresence SX20 Quick Set Administrator's Manual

Cisco TelePresence SX20 Quick Set
Contents

Conference settings

Conference [1..1] CallProtocolIPStack
Select if the system should enable IPv4, IPv6, or dual IP stack on the call protocol (SIP, H323).
Requires user role: ADMIN
Value space: <Dual/IPv4/IPv6>
Dual: Enables both IPv4 and IPv6 for H323 and SIP calls.
IPv4: When set to IPv4, the call protocol (SIP, H323) will use IPv4.
IPv6: When set to IPv6, the call protocol (SIP, H323) will use IPv6.
Conference 1 CallProtocolIPStack: Dual
Example:
Conference [1..1] AutoAnswer Mode
Set the auto answer mode.
Requires user role: ADMIN
Value space: <Off/On>
Off: An incoming call must be answered manually by pressing the OK key or the green Call
key on the remote control, or by tapping the Accept key on the Touch screen control panel.
On: Enable auto answer to let the system automatically answer all incoming calls.
Conference 1 AutoAnswer Mode: Off
Example:
Conference [1..1] AutoAnswer Mute
Determine if the microphone shall be muted when an incoming call is automatically answered.
Requires that AutoAnswer Mode is switched on.
Requires user role: ADMIN
Value space: <Off/On>
Off: The incoming call will not be muted.
On: The incoming call will be muted when automatically answered.
Conference 1 AutoAnswer Mute: Off
Example:
D14908.06 SX20 Administrator Guide TC7.0, DECEMBER 2013.
Introduction Web interface System settings System settings
Conference [1..1] AutoAnswer Delay
Define how long (in seconds) an incoming call has to wait before it is answered automatically by
the system. Requires that AutoAnswer Mode is switched on.
Requires user role: ADMIN
Value space: <0..50>
Range: Select a value from 0 to 50 seconds.
Conference 1 AutoAnswer Delay: 0
Example:

Conference [1..1] MicUnmuteOnDisconnect Mode

Determine if the microphones shall be unmuted automatically when all calls are disconnected.
In a meeting room or other shared resources this may be done to prepare the system for the
next user.
Requires user role: ADMIN
Value space: <Off/On>
Off: If muted during a call, let the microphones remain muted after the call is disconnected.
On: Unmute the microphones after the call is disconnected.
Conference 1 MicUnmuteOnDisconnect Mode: On
Example:
Conference [1..1] DoNotDisturb Mode
Determine whether to allow incoming calls.
Requires user role: USER
Value space: <Off/On/Timed>
Off: The incoming calls will come through as normal.
On: All incoming calls will be rejected and they will be registered as missed calls. The
calling side will receive a busy signal. A message telling that Do Not Disturb is switched
on will display on the Touch screen control panel or main display. NOTE: This setting is
not recommended as all calls will be rejected until the setting is manually turned off. The
recommended option is Timed.
Timed: When set to timed (default), the system will revert back and allow incoming calls after
the specified timeout, defined by the setting: Conference DoNotDisturb DefaultTimeout.
Conference 1 DoNotDisturb Mode: Timed
Example:
www.cisco.com — Copyright © 2012-2013 Cisco Systems, Inc. All rights reserved.
60
Administrator Guide
Setting passwords Appendices