Audio Volume - Cisco TelePresence SX20 Quick Set Administrator's Manual

Cisco TelePresence SX20 Quick Set
Contents
Audio Microphones Mute Enabled
Determine whether audio-mute is allowed or not. The default value is True.
Requires user role: ADMIN
Value space: <True/InCallOnly>
True: Muting of audio is always available.
InCallOnly: Muting of audio is only available when the device is in a call. When Idle it is not
possible to mute the microphone. This is useful when an external telephone service/audio
system is connected via the codec and is to be available when the codec is not in a call.
When set to InCallOnly this will prevent the audio-system from being muted by mistake.
Audio Microphones Mute Enabled: True
Example:
Audio SoundsAndAlerts KeyTones Mode
The system can be configured to make a keyboard click sound effect (key tone) when pressing
a key on the remote control, or when typing text or numbers on the Touch screen control panel.
Requires user role: USER
Value space: <Off/On>
Off: No key tones will be played when you type.
On: You will hear a key tone when you press a key or type text.
Audio SoundsAndAlerts KeyTones Mode: Off
Example:
D14908.06 SX20 Administrator Guide TC7.0, DECEMBER 2013.
Introduction Web interface System settings System settings
Audio SoundsAndAlerts RingTone
When using the Touch screen control panel: Choose a ringtone from the list. If the setting
UserInterface UserPreferences has been set to On, the Ringtone setting is available from the
Settings menu. If the setting UserInterface UserPreferences has been set to Off, the Ringtone
setting is available from the Administrator settings, and you must login with username and
password.
When using the on-screen menus and a remote control: Choose a ringtone from the list
When using the web interface: Enter the name of the ringtone for incoming calls. To see the
list of valid ringtones, navigate to Configuration > Personalization > Ringtone > Select active
ringtone.
When using a command line interface (API): Enter the name of the ringtone for incoming
calls. To see the list of valid ringtones, run the following API command: xCommand Audio
SoundsAndAlerts Ringtone List.
Requires user role: USER
Value space: <S: 1, 100>
Format: String with a maximum of 100 characters.
Audio SoundsAndAlerts RingTone: "Sunrise"
Example:
Audio SoundsAndAlerts RingVolume
Sets the ring volume for an incoming call.
Requires user role: USER
Value space: <0..100>
Range: The value goes in steps of 5 from 0 to 100 (from -34.5 dB to 15 dB). Volume 0 = Off.
Audio SoundsAndAlerts RingVolume: 50
Example:

Audio Volume

Set the speaker volume.
Requires user role: USER
Value space: <0..100>
Range: The value must be between 0 and 100. The values from 1 to 100 correspond to the
range from -34.5 dB to 15 dB (0.5 dB steps). The value 0 means that the audio is switched
off.
Audio Volume: 70
Example:
www.cisco.com — Copyright © 2012-2013 Cisco Systems, Inc. All rights reserved.
56
Administrator Guide
Setting passwords Appendices