Troubleshooting
Configuration change, some held jobs were not restored [57]
Held jobs are invalidated because of any of the following possible changes in the printer:
•
The printer firmware has been updated.
•
The tray for the print job is removed.
•
The print job is sent from a flash drive that is no longer attached to the USB port.
•
The printer hard disk contains print jobs that were stored when the hard disk was installed in a different printer
model.
Note: The printer hard disk and the flash drive are supported only in select printer models.
From the printer control panel, select Continue to clear the message. For non-touch-screen printer models, press
to confirm.
Defective flash detected [51]
Try one or more of the following:
•
Replace the defective flash memory card.
•
From the printer control panel, select Continue to ignore the message and continue printing. For non‑touch‑screen
printer models, press
•
Cancel the current print job.
Error reading USB drive. Remove USB.
An unsupported USB device is inserted. Remove the USB device, and then insert a supported one.
Error reading USB hub. Remove hub.
An unsupported USB hub has been inserted. Remove the USB hub, and then install a supported one.
Incompatible tray [x] [59]
Remove, and then reinstall the indicated tray to clear the message.
Incorrect paper size, open [paper source] [34]
Try one or more of the following:
•
Load the correct size of paper in the tray.
•
From the printer control panel, select Continue to clear the message and print using a different tray. For
non‑touch‑screen printer models, press
•
Check the tray length and width guides and make sure the paper is loaded properly in the tray.
•
Make sure the correct paper size and type are specified in the Printing Preferences or in the Print dialog.
•
Make sure the paper size and type are specified in the Paper menu on the printer control panel.
to confirm.
to confirm.
174