D6610 Cpu Card And D6615 Cpu Terminator Card; D6610 Cpu Card Connection; D6615 Cpu Terminator Card; Card Removal And Replacement - Bosch Conettix D6600 Installation And Operation Manual

Conettix D6600/D6100i | Installation and Operation Guide | 5.0 Power Supply Modules (D6600 Only)
4.2 D6610 CPU Card and D6615 CPU
Terminator Card
4.2.1

D6610 CPU Card Connection

The CPU card connects to the user interface on the
front of the D6600 using a 50-pin ribbon cable socket.
4.2.2

D6615 CPU Terminator Card

Figure 10: D6615 CPU Terminator Card

1
1 – Alignment Guide - Stabilizes the connection
and acts as a guide for connecting the
terminator card to the CPU card.
2 – COM3 Automation Computer Port - An auxiliary
RS-232 port for connecting to a computer
terminal or an automation computer for
SIA/6500 Mode Automation Format reporting
use a null-modem cable to connect to a
computer.
3 – COM4 RS-232 Port - Connection to a
computer running the D6200 programming
software.*
4 – Parallel Printer Port
* Use a null-modem cable to connect directly to
the computer. You can also connect this port to
a D6680 for communicating over a network.
12
4.2.3
Removing the CPU Card
1. Remove power to the receiver (refer to Section 7.7
2. Carefully grasp the plastic grip on the CPU card.
3. Unplug the 50-pin ribbon cable connecting the
4. Pull the CPU card straight out of the card guide.
Replacing the CPU Card
1. Remove power to the receiver (refer to Section 7.7
2
2. Remove the defective CPU card from the
3
3. Align the top and bottom of the CPU card with the
4
4. Connect the ribbon cable to the CPU card. Orient
5. Restore power to the receiver.
5.0 Power Supply Modules

6.0 Printer Specifications

Parallel printer connection: Use the DB25 port on the
back of the D6600/D6100i rear panel to connect to a
standard parallel text printer.
Models: Safecom SC9002 (Star 300) requires
82.6 mm. (3.25 in) wide paper.

Card Removal and Replacement

Remove power to the D6600 before
removing, replacing, or installing the CPU
card (D6610) or CPU terminator card
(D6615).
Removing Power to the Receiver on page 14).
Slide it 2 in. to 3 in. (50 mm to 75 mm) out of the
enclosure.
user interface card to the CPU card. Be careful not
to bend the board when disconnecting this cable.
Grasp the plastic plug connected to the CPU board
at the end of the cable and gently pull it away from
the circuit board.
Removing Power to the Receiver on page 14).
enclosure.
card guides. Slide the card into the enclosure,
leaving 2 to 3 in. (50 mm to 75 mm) out to connect
the ribbon cable.
the cable so the red stripe is up and slide the card
the remaining distance into the enclosure.
(D6600 Only)
The AC/DC (D6630) and DC/DC
(D6631) Power Supply Modules are not
field serviceable.
Contact the Bosch Security Systems, Inc.
National Repair Center at (800) 289-
0096 for repair or replacement.
Bosch Security Systems, Inc. | 8/07 | 4998122704-02