D6640/D6641 Led Descriptions; Card Installation; Figure 8: D6640/D6641 Led Descriptions - Bosch Conettix D6600 Installation And Operation Manual

Communications receiver/gateway
Hide thumbs Also See for Conettix D6600:
Table of Contents

Advertisement

Conettix D6600/D6100i | Installation and Operation Guide | 4.0 D6600 Specific Cards
4.1.1

D6640/D6641 LED Descriptions

The LED is active until the system acknowledges the
entire transmission and the telephone line is ready to
receive signals.
Figure 8:
D6640/D6641 LED Descriptions
1
2
3
4
OL/LF
1 – Flashes green when an incoming call rings.
2 – Glows green when the receiver is online with
an incoming call.
3 – Glows red when the line card detects a line
fault condition.
4 – LED is off and ready to receive signals or is
disabled in the software.
10
4.1.2
Installing Terminator Cards
Refer to Figure 9 on page 11 when performing the
following steps:
1. Remove the two bracket screws that secure the
1
2. If you are removing an existing terminator card,
2
3
4
3. Remove the existing terminator card.
4. Insert the new terminator card in the same slot by
5. Slide the card into the D6600 chassis, wiggling the
6. Secure the bracket screws at the top and bottom of
7. Repeat this process for all additional terminator
8. Connect appropriate telephone line cords to the
9. Continue with Installing Line Cards on page 11.

Card Installation

Discharge static electricity from your body
by touching the receiver's internal frame
(unpainted section) before handling any
circuit card.
terminator card (or card slot cover, if this is a new
terminator card installation) to the back of the
D6600 chassis.
open the display door on the front of the D6600
and pull the line card slightly out, then re-insert.
This will push the existing terminator card out the
back of the D6600 chassis.
aligning the top and bottom of the terminator card
with the card guides in the D6600 chassis.
card as you push until the card is flush with the
back of the chassis.
the terminator card. Ensure that the screws are
tight.
cards.
telephone line jack on the terminator cards.
Even if you are replacing an existing
terminator card, you must proceed to
Installing Line Cards on page 11.
Bosch Security Systems, Inc. | 8/07 | 4998122704-02

Advertisement

Table of Contents
loading

This manual is also suitable for:

Conettix d6100i

Table of Contents