Telephone Line Monitoring Voltage; D6610 Cpu Card And D6615 Cpu Terminator Card; D6610 Cpu Card Connection; D6615 Cpu Terminator Card - Bosch D6600 Operation And Installation Manual

.
7. Mount the terminator card (Item 1, Figure 9 on page
10) in an empty slot (Item 3, Figure 9) of the
receiver cabinet (Item 4, Figure 9) by securing the
bracket screws at the top and bottom (Item 2,
Figure 9) of the terminator card to the mounting
rails at the top and bottom edges of the cabinet.
Ensure the screws are tight.
8. Repeat this process for all additional terminator
cards.
Do not install spare line cards and do not
connect line cards to the spare terminator
cards.
9. Connect appropriate telephone line cords to the
telephone line jack on the terminator cards.
Installing Telephone Line Cards
1. Install the telephone line terminator card(s) (refer
to Installing Telephone Line Terminator Cards on page
10).
2. Open the display door on the receiver.
One telephone line card is installed in the receiver
when shipped from the factory.
3. Slide a line card into the slot next to the installed
line card.
4. Remove the appropriate snap-in covers from the
front of the panel.
5. Close the front panel.
6. Program the line card if necessary.
When the line card is initialized (as indicated by a
printer report), the settings in the line card
programming section automatically load into the
card.
7. Connect telephone lines to the line card
4.1.3

Telephone Line Monitoring Voltage

The receiver continuously monitors the telephone line
voltage. Normal operating voltage ranges from
1.8 VDC to 2.5 VDC. Any voltage above 2.5 VDC
causes the line to appear good (restoral) and an
indication appears if any voltage is below 1.8 VDC.
Bosch Security Systems | 2/05 | 4998122704E
D6600 | Operation and Installation Guide | 4.0 D6600 Specific Cards
4.2 D6610 CPU Card and D6615 CPU
Terminator Card
4.2.1

D6610 CPU Card Connection

The CPU card connects to the user interface on the
front of the D6600 using a 50-pin ribbon cable socket.
4.2.2

D6615 CPU Terminator Card

Figure 10: D6615 CPU Terminator Card

1
1 - Alignment Guide - Stabilizes the connection
and acts as a guide for connecting the
terminator card to the CPU card.
2 - COM3 Automation Computer Port - An auxiliary
RS-232 port for connecting to a computer
terminal or an automation computer for
SIA/6500 Mode Automation Format reporting
use a null-modem cable to connect to a
computer.
3 - COM4 RS-232 Port - Connection to a
computer running the D6200 programming
software.*
4 - Parallel Printer Port
* Use a null-modem cable to connect directly to
the computer. You can also connect this port to
a D6680 for communicating over a network.
2
3
4
11