Using The Central Station Automation System With The Receiver; Figure 18: Receiver System - Direct Connect - Bosch Conettix D6600 Installation And Operation Manual

Conettix D6600/D6100i | Installation and Operation Guide | 13.0
.
13.0 Using the Central Station
Automation System with
the Receiver
If using a Bosch Security Systems, Inc. receiver,
connect a central station automation system computer
to the COM3 port (automation computer port) on the
rear of the receiver with a null-modem cable. Refer to
the D6600/D6100i Computer Interface Manual
(P/N: 4998122703) for additional information.
Standard automation reporting usually sends RS-232
serial data from the receiver COM3 port to a COM
port of a separate automation PC (refer to COM3
Automation Configuration in the D6600/D6100i Program
Entry Guide [P/N: 4998122702]). With no additional
programming required at the D6600, you can use the
same serial communication across a network
connection by using D6680s at both ends of the
automation communication path. The D6600 still sends
the standard serial data, but the D6680s communicate
with each other, convert the data back to the standard
RS-232 that the automation computer can interpret,
and transmit that data back over the network.
Some messages might go
unacknowledged (NACK) due to
increased network activities. This forces
the D6600 to resend these messages.
Refer to the Conettix D6600 Network
System Guide (P/N: 4998122712) for
complete details on network
communications and programming.
Bosch Security Systems, Inc. | 8/07| 4998122704-02
Using the Central Station Automation
Figure 18: Receiver System – Direct Connect
1
1 – Host PC
2 - Connection – Host PC COM1 port to D6100i
3 - D6100i
4 – D6600 Receiver
5 – Connection - Host PC COM1 Port to D6600
COM3 Port
System with the Receiver
2
3
5
4
27