Cable Specifications
If you prefer to build your own cables, this appendix provides cable specifications for the
Cisco ASR 901 10G router.
The appendix includes the following sections:
•
•
•
•
•
•
•
•
•
•
To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety,
Warning
use only shielded cables that are grounded on both ends for Type 2 and Type 4 ports that require
shielded cables.
Gigabit Ethernet Connector Pinouts
This section illustrates the Gigabit Ethernet RJ-45 connector and lists its pinout and signal descriptions.
The RJ-45 ports are capable of operating in both 100BaseT and 1000BaseT modes.
Note
Figure B-1
OL-28105-02
Gigabit Ethernet Connector Pinouts, page B-1
shows the RJ-45 connector and port, and
Cisco ASR 901 10G Series Aggregation Services Router Hardware Installation Guide
A P P E N D I X
Table B-1
lists the connector pinouts and signals.
B
B-1