Table of Contents
Advertisement
Installing the Switch
StackPower Partitioning Examples
Figure 2-13
conditions. In
redundancy.
Figure 2-13
STACK 1
STACK 1
STACK 1
In
Figure
stacks. The top two switches share power, and the bottom switch is now a separate stack.
Figure 2-14
STACK 1
STACK 1
STACK 1
Installing the Switch
•
•
•
The illustrations shown in this section show the Catalyst 3750-X-48 PoE switch as an example. You can
install the Catalyst 3750-X and 3560-X switches following the same procedures.
Catalyst 3750-X and 3560-X Switch Hardware Installation Guide
2-14
and
Figure 2-14
show StackPower stacks of Catalyst 3750-X switches with failover
Figure
2-13, the StackPower cable 2 is faulty. Therefore, this stack does not provide
Example of a StackPower Stack with a Failover Condition
1
STACK 2
2
STACK 2
3
STACK 2
2-14, StackPower port B on the center switch has failed and this stack partitions into two
Example of a Partitioned StackPower Stack with a Failover Condition
1
STACK 2
STACK 2
2
STACK 2
Rack-Mounting, page 2-15
Table- or Shelf-Mounting, page 2-19
After Installing the Switch, page 2-19
Chapter 2
Switch Installation
OL-19593-02
Advertisement
Table of Contents
