Selecting Watch Points - Bosch Security Systems User Manual

Selecting Watch Points

Once you decide how your system responds to watched points (see
Selecting Watch Tone on page 21), you need to decide which of the points in
your system are to be watched. Use this feature to tell your system which
points to watch. You cannot watch fire points.
Choosing which points to watch depends upon your goals. If you have
small children, you may choose to watch points of entry and exit. Each
time a watch point is faulted (door or window is opened) the keypad
responds as programmed. For example, you may tell your system to
produce a short beep when a watch point is faulted.
If you just want to review (not change) current watch point settings, press
the [8] key. The display scrolls the current setting for each point.
1. Make sure that your system is off (On light is off).
2. Press the [8] key and enter your passcode. The display shows all of
the points that are currently being watched (Watch On) and those
that are not (Watch Off), followed by instructions for changing the
current setting. The example below shows that Watch is Off for
point 2:
Follow the displayed instructions to change the current setting. In
this case, to make point 2 a watch point you would press [2] [ ].
The display confirms your choice.
3. The display continues to scroll the remaining points. You may
continue to select or deselect as many watch points as are available.
When you are finished, press the [CLEAR] key to return to the off
state.
22
PT 2 WATCH OFF
FRONT DOOR
PRESS 2
TURN PT 2 ON
PT 2 WATCH ON
FRONT DOOR
TO