Silencing Alarms - Bosch Security Systems User Manual

Silencing Alarms

When there is an alarm, the alarm tone sounds and the point or points in
alarm are shown in the display. If you enter your passcode before the
system dials your security company, the alarm is canceled.
1. The point in alarm is shown on the display:
2. Enter your passcode to silence the alarm and turn the system off (if
it was turned on). If you enter your passcode before the system
dials your alarm company, the alarm is canceled. If not, an alarm
report is sent to your alarm company. To determine whether the
alarm was reported, follow the procedure to View Alarm Memory
(on page 19). The display continues to show the point or points
that caused the alarm:
3. Press the [CLEAR] key to remove the alarm messages from the
display.
4. Use Viewing Alarm Memory (on page 19) to review the points that
caused the alarm. Use Resetting the System (on page 20) to reset
system points.
ALARM PT 8
MOTION DETECTOR
ENTER CODE TO
TURN SYSTEM OFF
ALARM PT 8
MOTION DETECTOR
TO REMOVE ALARMS
PRESS CLEAR
11