Threading The Upper Thread - Viking Emerald 203 User Manual

C
E
THREADING THE
UPPER THREAD
Make sure the presser foot is raised and the
needle is in the up position.
Turn off the main switch.
1. Pull the spool pin up. Place a spool cap and
then the thread on the spool pin. Place the
second spool cap on the spool pin (A). Push
the spool pin back in.
2. Bring the thread in the direction of the
arrow under the thread guide (B) so that
the thread snaps into place. Then bring the
thread under the second thread guide (C).
3. Bring the thread down between the thread
tension discs (D).
4. Continue threading by drawing the thread up
into the slot on the take-up lever (E) from
the right to the left.
5. There are two thread guides close to the
needle: (F) and (G). Insert the thread into the
two thread guides.
6. The needle is threaded from front to back.
The white on the presser foot ankle makes it
easy to see the eye of the needle. See needle
threader instructions on the next page.
7. Place thread under the presser foot and into
the thread cutter where it is cut.
18
B
A
E
G
D
F