Presser Foot; Bobbin Cover - Viking Interlude 445 User Manual

Care of your Interlude
Care of the Machine
To keep your sewing machine operating
well, clean it often. No lubrication
(oiling) is needed.
!
Turn off the main switch.
Cleaning
Wipe the exterior surfaces of your
Interlude with a soft cloth to remove
any dust or lint built up.
Clean the Bobbin Area
Remove the presser foot and slide off
the bobbin cover. Lower the feed teeth.
Place the stitch plate opener on the
brush, and then in the recess at the rear
of the stitch plate. Turn toward you to
pop off the stitch plate. Clean the feed
teeth with the brush.
Cleaning Under the Bobbin Area
When lint builds up, the area under the
bobbin case must be cleaned.
Remove the bobbin case holder (1)
covering the front part of the bobbin
case (2). Remove the bobbin case by
lifting it up. Clean with the brush.
2
Replace the bobbin case and the bobbin
case holder.
1
Replacing the Stitch Plate
With feed teeth down, place the stitch
plate about 5 mm in front of the rear
edge and push it back. Slide on the
bobbin cover. Raise the feed teeth.
49