Threading The Upper Thread - Viking Scandinavia 300 User Manual

Learn your Scandinavia 300
Threading the upper
thread
Turn off the main switch.
Make sure the presser foot is raised
and the needle is in the up po si tion
1. Pull the spool pin out. Place the
thread on the spool pin and the
spool holder on the spool pin
as described. Push the spool pin
back in.
2. Bring the thread in the direction
of the arrow under the thread
guide (a) and over the thread
guide (b).
3. Bring the thread down between
the thread tension discs.
4. Continue threading by drawing
the thread from the right into the
slot on the take-up lever.
5. Thread last guide just above
needle.
6. The needle is threaded from front
to back. The white on the presser
foot ankle makes it easy to see
the eye of the needle.
7. Place thread under the presser
foot and into the thread cutter
where it is cut.
Upper thread warning
If the upper thread breaks or if
thread spool runs out, the machine
stops and gives a signal. The symbol
is fl ashing on the display.
If thread breaks: Re-thread the
machine. The symbol goes out. If
thread spool runs out: Remove your
work and the bobbin. Re-thread the
machine. Replace the bobbin and
restart.
6
4
b
7
3
5
6
2
1
a