Button - Viking Interlude 445 User Manual

Button

Sew buttons, snaps, hook and eyes
quickly with your Interlude.
Fabric: Woven medium
445
04
Use the clearance plate to create a
thread shank. Snap off the presser foot
and lower the feed teeth by turning the
dial on the free arm to
Adjust stitch settings so that the stitch
length is 0.0 and the width is 3.0. Set
thread tension to 4 and presser foot
pressure to 6.
Sew:
• Place the thin end of the clearance
plate under the button when sewing
on light fabrics. Hold in place with
transparent tape. Use the thick end
for heavier fabrics.
• Place the button under the ankle
with the holes in the button lined up
with the swing of the needle. Check
the swing of the needle by touching
the mirror side to side button
to be sure the needle will not hit the
button. Bring the needle down into
the hole of the button with the hand
wheel to verify.
• Zigzag button in place with six to
eight stitches.
• Touch to tie off.
• Raise feed teeth when button sewing
is completed.
• To deactivate the
.
435
03
80
.
function touch
STOP
Sewing
41