Fax Status - Multitech FaxFinder FF130 Administrator's Manual

Fax Status

Fax Status shows current state of modems as well as inbound and outbound faxes. Also, Administrators
can view and change the state of internal modems.
Modem Status
Shows the current condition of each internal modem.
Field
Modem The sequential modem number associated with each internal modem based on the
FaxFinder model (1 for the FF130, 1-2 for the FF230, 1-4 for the FF430 and 1-8 for
the FF830).
State The current modem state: Waiting for Ring, Connected, and Busied Out.
Page The page that a modem is currently transmitting, if any.
Vertical The resolution used to transmit the page. Vertical scan line types include fine and
Resolution standard.
Baud Rate The modem's current baud rate.
Width The current width setting for faxes sent through the listed modem.
Length The current length setting for faxes sent through the listed modem.
Connect Time When the current connection was made.
Elapsed Time The time that has passed since the current connection was made.
Remote ID The identification received from the remote connection.
Phone Number When sending, this is the phone number that was dialed. When receiving, this is
the DID number detected.
Action Administrator only.
Option
Initialize
Busy
FaxFinder Administrator User Guide
Description
Click this link to send the initialization command to the modem. This
will remove a busy-out state from a modem. When initialization is
complete, "Modem x initialized" appears in color at the top of the
page. If you click this while a fax is in progress, it will interrupt the
fax and cause it to fail.
Click this link to set the modem to a busy state so that it cannot send
or receive faxes. Any incoming calls to this modem will receive the
busy tone. To allow the modem to send faxes, click the modem's
Initialize link.
Chapter 3: FaxFinder Web Management Interface
Description
29