Table of Contents
Advertisement
Aimer Delay
The aimer delay allows a delay time for the operator to aim the imager before the
picture is taken. Use these codes to set the time between when the trigger is
pulled and when the picture is taken. During the delay time, the aiming light will
appear, but the LEDs won't turn on until the delay time is over.
200 milliseconds
400 milliseconds
* Off
(no delay)
User-Specified Aimer Delay
If you want to set your own length for the duration of the delay, scan the bar code
below, then set the time-out by scanning digits (0 - 4,000 ms) from the
Programming Chart
inside the back cover of this manual, then scan Save.
Delay Duration
Aimer Mode
This feature allows you to turn the aimer on and off. When the Interlaced bar
code is scanned, the aimer is interlaced with the illumination LEDs.
Off
* Interlaced
4 - 10
2020/4820/4820i User's Guide
Advertisement
Table of Contents
