Table of Contents
Advertisement
Serial Wedge
To set up the serial wedge terminal ID, use the serial terminal ID 050 and follow
the instructions on
page
2-7. Make sure that all of the communication
parameters match on all of the connected devices. Choosing Both sends
scanned data to P1 and P2. Default = P1.
* P1
P2
Both P1 and P2
Programming the Interface - Terminal ID Method
If your interface is not a standard PC AT, refer to
Supported Terminals,
beginning
on page 2-8, and locate the Terminal ID number for your PC. Scan the Terminal
ID bar code below, then scan the numeric bar code(s) from the
Programming
Chart
inside the back cover of this manual to program the imager for your
terminal ID. Scan Save to save your selection.
For example, an IBM AT terminal has a Terminal ID of 003. You would scan the
Terminal ID bar code, then 0, 0, 3 from the
Programming Chart
inside the back
cover of this manual, then Save. If you make an error while scanning the digits
(before scanning Save), scan the Discard code on the
Programming
Chart, scan
the Terminal ID bar code, scan the digits, and the Save code again.
Note: The default interface is Keyboard Wedge (Term ID = 003).
Terminal ID
Save
Note: After scanning one of these codes, you must power cycle your computer.
2020/4820/4820i User's Guide
2 - 7
Advertisement
Table of Contents
