Table of Contents
Advertisement
2
Programming the Interface
Introduction
Chapter 1 describes connecting the base to the computer with the appropriate
interface cable. This chapter describes how to program your system for the
desired interface.
Programming the Interface - Plug and Play
Plug and Play bar codes provide instant imager set up for commonly used
interfaces.
Note: After you scan one of the codes, power cycle the host terminal to have the
interface in effect.
Keyboard Wedge Connection
If you want your system programmed for an IBM PC AT and compatibles
keyboard wedge interface with a USA keyboard, scan the bar code below.
Keyboard wedge is the default interface.
Note: The following bar code also programs a carriage return (CR) suffix.
Laptop Direct Connect
For most laptops, scanning the Laptop Direct Connect bar code allows
operation of the imager in parallel with the integral keyboard. The following
Laptop Direct Connect bar code selects terminal ID 03, programs a carriage
return (CR) suffix and turns on Emulate External Keyboard
2020/4820/4820i User's Guide
IBM PC AT and Compatibles
with CR suffix
Laptop Direct Connect
with CR suffix
(page
2-13).
2 - 1
Advertisement
Table of Contents
