Setup; Ac Power; Fuse Replacement - Chauvet Geyser User Manual

3. S
ETUP

AC Power

Fuse
Replacement
Geyser™ RGB User Manual Rev. 6
The Geyser™ RGB has a fixed voltage power supply and it can work with an input
voltage of either 120 V, 60 Hz or 230 V, 50 Hz, depending on the specific model.
To determine the product's power requirements (circuit breaker, power outlet, and
wiring), use the current value listed on the label affixed to the product's panel, or refer to
the product's specifications chart. The listed current rating indicates the product's
average current draw under normal conditions.
Always connect the product to a protected circuit (circuit breaker or fuse). Make
sure the product has an appropriate electrical ground to avoid the risk of
electrocution or fire.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0–100% switch.
Disconnect the product from power before replacing the fuse.
1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the fuse holder out of the housing.
4. Remove the blown fuse from the holder.
5. Replace with a fuse of the exact same type and rating.
6. Insert the fuse holder back in place and reconnect power.
Spare fuse holder
(inside safety cap)
A spare fuse is not included; however, the safety cap has room for a spare.
Always replace a blown fuse with another of the same type and rating.
Installed fuse
(held by plastic clip)
Safety cap
Page 7 of 16