Setup; Ac Power; Fuse Replacement - Chauvet Hurricane Haze 1D User Manual

3.

Setup

AC Power

This product can work with an input voltage of either 120 VAC, 60 Hz or 230 VAC, 50 Hz
depending on the model.
To determine the power requirements for a particular product, see the label affixed to the
back plate of the product or refer to the product's specifications chart. The listed current
rating indicates the product's average current draw under normal conditions.
Always connect this product to a protected circuit (circuit breaker or fuse), making
sure that it has an appropriate electrical ground to avoid the risk of electrocution or
fire.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0 to 100% switch.

Fuse Replacement

Disconnect this product from the power outlet before replacing the fuse.
1.
2.
3.
4.
The product does not ship with a spare fuse; however, the safety cap has room for
a spare.
Hurricane Haze 1D User Manual Rev. 1
Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
Pry the fuse out of the housing.
Remove the blown fuse from the holder and replace with a fuse of the exact same
type and rating.
Insert the fuse holder back in place and reconnect power.
Spare fuse holder
(inside safety cap)
Installed fuse (held
by plastic clip)
Safety cap
Page 7 of 16