Part 3 -Network Connection Administration - Sun Microsystems Netra User Manual

Part 3 — Network Connection
Administration
The chapters in Part 3 describe the Netra server's Network Connection
Administration modules.
•
Chapter 9, "ATM Administration," describes how to set up a connection to
an Asynchronous Transfer Mode (ATM) network.
•
Chapter 10, "High-Speed Serial Interface Administration," describes how to
connect the Netra server to a remote host using an HSI interface and PPP.
•
Chapter 11, "ISDN Administration," describes how to connect the Netra
server to a remote host using ISDN and PPP.
•
Chapter 12, "Local Area Network Administration," describes how to
configure the LAN interfaces on a Netra server.
•
Chapter 13, "Modem Administration," describes how to connect the Netra
server to a remote host using a modem and PPP.
•
Chapter 14, "Routing Administration," describes how to configure the Netra
server as a router.
Note – The Netra software does not display information on high-speed serial,
ISDN or Token Ring interfaces if the necessary interface hardware and
software are not installed in the Netra server. (Refer to your Netra hardware
installation manual for instructions on adding network interface hardware.
Refer to the Software Management module for software installation
instructions. Then configure the interface using the following chapters.)