Installing The Main Battery - Motorola MC9190-G User Manual

1 - 2 MC9190-G User Guide
Unpacking
Carefully remove all protective material from around the MC9190-G and save the shipping container for later
storage and shipping.
Verify that you received all equipment listed below:
•
mobile computer
•
lithium-ion battery
•
strap, attached to the MC9190-G
•
stylus, in the stylus silo
•
Regulatory Guide
•
Quick Start Guide.
Inspect the equipment for damage. If you are missing any equipment or if you find any damaged equipment,
contact the Motorola Global Interactive Center immediately. See
Getting Started
In order to start using the MC9190-G for the first time:
•
install the main battery
•
charge the main battery and backup battery
•
start the MC9190-G
•
configure the MC9190-G.
The main battery can be charged before or after it is installed. Use one of the spare battery chargers to charge the
main battery (out of the MC9190-G), or one of the cradles to charge the main battery installed in the MC9190-G.

Installing the Main Battery

Before using the MC9190-G, install a lithium-ion battery by sliding the battery into the MC9190-G as shown in
Figure 1-2.
NOTE Ensure the battery is fully inserted. Two audible clicks can be heard as the battery is fully inserted. A partially
inserted battery may result in unintentional data loss.
When a battery is fully inserted in a MC9190-G for the first time, upon first power up, the device boots and powers
on automatically.
page xii for contact information.