Removing The Side Cover - IBM System x3200 Installation Manual

Removing the side cover

To remove the server side cover, complete the following steps:
1. Review the safety information that begins on page v and the "Installation
2. Turn off the server and all attached devices (see "Turning off the server" on
3. Lay the server on its side.
4. Unlock the side cover; then, press the cover-release latch down, as indicated by
5. Lift the side cover off the server and set it aside.
To replace the side cover, see "Reinstalling the side cover" on page 34.
Attention:
the server. Operating the server for extended periods of time (more than 30
minutes) with the cover removed might damage server components.
10
System x3200 Type 4362 and 4363: Installation Guide
guidelines" on page 7.
page 41); then, disconnect all power cords and external cables.
the two arrows on the latch.
Cover-release
latch
Key lock
For proper cooling and airflow, replace the cover before you turn on